Complete the following steps to configure and setup SEM. When this is done the installation can be completed.

1. A welcome window indicates that you have reached the setup part of the installation process. Continue by clicking Next.

2. Configure proxy server by selecting whether or not your server uses a proxy server to connect to the Internet.

       If you select No, simply click Next and jump to step 3,

       If you select either of the Yes checkboxes (Windows or custom authentication), then read below for information

       on how to actually configure the proxy. When you have configured your proxy, continue by clicking Next.

       Windows authentication

       Fill in the appropriate fields. A valid username and password, as well as a domain name.

       Custom authentication

       With a custom authentication you must also fill in a valid username and password, however, no domain name is

       required here.

3. Select and specify a service account. It is important you notice, that your SEM installation needs to run in authorized context, when accessed. In other words, SEM needs to be executed in the context of a service account. Here you must select whether an existing service account should be used, or if a new should be created.

       Whether you select to use an existing account, or create a new one, you must specify a valid username, a

       password, and fill in an appropriate domain name. When this is done, you must click Next to continue.

4. If a Windows Cluster has been detected the following page will be shown - it no cluster has been detected this page

will be skipped automatically.

The installation has tried to automatically detect the name of the clustered Exchange server - and the Quorum Drive (=Shared Cluster Disk).

Please verify that the information is correct - and if not, enter the correct information.

5. Ready to install. When your service account has been validated, the setup process can continue. Click Next to proceed.

6. Contacting the SEM server. Simply wait until the configuration of the SenderFilter window appears.

7. Pre-configuring the SenderFilter. You are able to configure the SenderFilter, i.e. adding or removing your internal domains from the whitelist. Note, that this is also possible through the Administration module later on, it does not necessarily have to be done now. Click Next to continue.

8. Configure security. It is important that you determine which user groups should be allowed to change settings through the Administration module. The available user groups are listed in the "Active Directory box" to the left. Use the arrow button

9. Configure automatic update. The SEM can be enabled to update itself, or inform you when updates are available. Simply mark the checkbox "Enable automatic update", if SEM should be enabled to update itself. You can also enter your email, so you in any case are informed whenever updates are available. Click Next to continue.

Remember to specify when the SEM should look for updates, i.e. day of the week and time of day.

10. Setting configuration. Wait until the configuration has been set, and the Finished window appears.

11. Finished. You have now completed the setup part, the installation can now be completed. Click Finish to close the setup window, and you are returned to the main installation procedure.

Complete Installation

Click Finish to complete the installation.

When the installation is complete a webbrowser is opened, and a short confirmation text is displayed.

From here, we suggest you read the Using the SEM section, for detailed information on how the Administration module is operated. If you, however, have experienced any unexpected errors during installation, please see the Troubleshooting section - you might be able to find a solution to your problem here.